D-Link xStack DGS-3420 Series Reference Manual page 771

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
DGS-3420-28SC:admin#config power_saving hibernation add time_range range_1
Command: config power_saving hibernation add time_range range_1
Success.
DGS-3420-28SC:admin#
70-3 config power_saving led
Description
This command is used to add or delete the power saving schedule on the LED of all ports. When any
schedule is up, all port's LED will be turned off even device's LED working on PoE mode.
Note: The port LED admin state (configured using the command 'config led state') gets high
priority. If the port LED admin state is disabled, all ports' LED will always be turned off.
Currently only three time ranges are supported.
Format
config power_saving led [[add | delete] time_range <range_name 32> | clear_time_range]
Parameters
add - Specify to add a time range.
delete - Specify to delete a time range.
time_range - Specify the name of the time range.
<range_name32> - Enter a name for maximum 32 characters.
clear_time_range - Specify to clear all the time range of port LED.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To add a time range named "range_1" on port LED:
DGS-3420-28SC:admin#config power_saving led add time_range range_1
Command: config power_saving led add time_range range_1
Success.
DGS-3420-28SC:admin#
766