Connecting A Fiber-Optic Cable To The Acx6160 - Juniper ACX6160 Hardware Manual

LASER WARNING: Do not look directly into a fiber-optic transceiver or into the ends
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to
transceivers emit laser light that can damage your eyes.
LASER WARNING: Do not stare into the laser beam or view it directly with optical
instruments even if the interface has been disabled.
2. Carefully unplug the fiber-optic cable connector from the transceiver.
3. Cover the transceiver with a rubber safety cap.
LASER WARNING: Do not leave a fiber-optic transceiver uncovered except when
inserting or removing a cable. The rubber safety cap keeps the port clean and prevents
accidental exposure to laser light.
4. Cover the fiber-optic cable connector with the rubber safety cap.

Connecting a Fiber-Optic Cable to the ACX6160

Before you connect a fiber-optic cable to an ACX6160, ensure that you have taken the necessary
precautions for safe handling of lasers (see
and "Laser and LED Safety Guidelines and Warnings" on page
The ACX6160 has optical transceivers to which you can connect fiber-optic cables.
To connect a fiber-optic cable to an optical transceiver installed in the ACX6160:
LASER WARNING: Do not look directly into a fiber-optic transceiver or into the ends of
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to
transceivers emit laser light that can damage your eyes.
LASER WARNING: Do not stare into the laser beam or view it directly with optical
instruments even if the interface has been disabled.
1. If the fiber-optic cable connector is covered by a rubber safety cap, remove the cap. Save the cap.
2. If the optical transceiver is covered by a rubber safety cap, remove the cap. Save the cap.
"Radiation from Open Port Apertures Warning" on page 119
116).
82