Configure Inline-Power Operator-Limit Ports - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Power Over Ethernet Commands

configure inline-power operator-limit ports

configure inline-power operator-limit <milliwatts> ports [all |<port_list>]
Description
Sets the power limit allowed for PDs connected to the specified ports.
Syntax Description
milliwatts
port_list
Default
15400 mW.
Usage Guidelines
This command sets the power limit that a PD can draw on the specified ports. Range is 3000 to
16800 mW; the default value is 15400 mW.
If the measured power for a specified port exceeds the port's operator limit, the power is withdrawn
from that port and the port moves into a fault state.
If you try to set an operator-limit outside the accepted range, the system returns the following error
message:
Error: Invalid operator-limit value. Must be in the range of 3000-16800 mW
Example
The following command sets the limit for legacy PDs on ports 3 – 6 of slot 5 on a modular switch to
10000 mW:
configure inline-power operator-limit 10000 ports 5:3-5:6
History
This command was first available in ExtremeWare XOS 11.1.
Platform Availability
This command is available on the G48P and G48Pe modules installed in the BlackDiamond 8800 series
switch and the Summit X450e-24p switch.
516
An integer specifying the maximum allowed power in milliwatts; the range is
3000 to 16800 mW.
NOTE: If you attempt to enter a higher value, the switch returns an error
message.
Specifies one or more ports or slots and ports.
ExtremeWare XOS 11.5 Command Reference Guide