Enable Dot1P Examination Ports - Extreme Networks ExtremeWare XOS Command Reference Manual

Software version 11.5

Hide thumbs Also See for ExtremeWare XOS:

Table of Contents

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

enable dot1p examination ports

enable dot1p examination ports [<port_list> | all]

Allows the 802.1p priority field to be examined as part of the QoS configuration.

Syntax Description

Usage Guidelines

To increase available ACLs, you can disable the 802.1p examination feature if you are not running QoS

or are running QoS using DiffServ. See ExtremeWare XOS Concepts Guide for information on ACL

limitations on these platforms.

Use this command to re-enable the 802.1p examination feature.

The following command enables dot1p examination on ports 1 to 5:

enable dot1p examination ports 1-5

This command was available in ExtremeWare XOS 11.4.

Platform Availability

This command is available only on the BlackDiamond 8800 series switch and the Summit X450 family of

ExtremeWare XOS 11.5 Command Reference Guide

Specifies a list of ports or slots and ports.

Specifies that dot1p examination should be enabled for all ports.

enable dot1p examination ports

Extremeware xos 11.5