Unconfigure Vman Ratelimit Flood-Traffic Designated-Port - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

unconfigure vman ratelimit flood-traffic designated-port

unconfigure vman <vman_name> ratelimit flood-traffic designated-port
Description
Removes the control on flooding, multicast, and broadcast traffic in a vMAN with egress rate-limiting
applied.
Syntax Description
vman_name
Default
N/A.
Usage Guidelines
Use this command to remove the control on flooding, multicast, and broadcast traffic in the vMAN with
egress rate limiting.
To display the port you designated to use the rate-limit profile that controls the flooding traffic for the
vMAN with egress rate limiting enabled, issue the
The following is sample output from this command (information is displayed on the ERL Designated
Port line):
VMAN Interface with name vman400 created by user
Admin State:
Priority:
Virtual router: VR-Default
IPv6:
STPD:
Protocol:
Loopback:
NetLogin:
ERL Designated Port:
QosProfile:
Ports: 0.
Example
The following command removes the control of flooding, multicast, and broadcast traffic in the egress
rate-limit enabled vMAN metro:
unconfigure vman metro ratelimit flood-traffic designated-port
ExtremeWare XOS 11.5 Command Reference Guide
unconfigure vman ratelimit flood-traffic designated-port
Specifies the egress rate-limited enabled vMAN for which you are removing the
control on flooding, multicast, and broadcast traffic.
show vman detail
Enabled Tagging:
802.1P Priority 0
None
None
Match all unfiltered protocols
Disabled
Disabled
Not configured
QP1
(Number of active ports=0)
command.
802.1Q Tag 400
945