Configure Traffic Queue Aggregate-Meter - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
QoS Commands

configure traffic queue aggregate-meter

configure traffic queue <queue_name> aggregate-meter <metername>
Description
Configures the aggregate rate limit for the HQoS queue by associating the specified queue with the
specified meter.
Syntax Description
queue_name
metername
Default
N/A.
Usage Guidelines
You use this command with all types of HQoS traffic queues: ingress-only, ingress queues that allow
egress shaping, and egress queues.
This command creates the aggregate rate limit for the specified queue by associating that queue with
the meter containing a peak rate value.
Example
The following command configures the test traffic queue with an aggregate rate limit specified by the
peak rate in the m1_100 meter:
configure traffic queue test aggregate-meter m1_100
History
This command was first available in ExtremeWare XOS 11.4.
Platform Availability
This command is available only on the BlackDiamond 12804 R-Series switch.
896
Specifies the traffic queue you are configuring.
Specifies the meter you are associating with this queue, which contains the
peak rate for the queue.
ExtremeWare XOS 11.5 Command Reference Guide