Extreme Networks ExtremeWare XOS Command Reference Manual page 372

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Commands for Configuring Slots and Ports on a Switch
The following command displays the connectivity and configuration of neighboring Extreme Networks
switches:
show edp ports 1:1 detail
Following is sample output from this command:
=============================================================================
Port 1:1: EDP is Enabled
Tx stats: sw-pdu-tx=2555
Rx stats: sw-pdu-rx=2511
Time of last transmit error: None
Time of last receive error:
Remote-System:
Remote-ID:
Software version:
Remote-Port:
Port Type:
Auto Negotiation:
Flow Control:
Duplex Speed:
Port Speed (MB):
Remote-Vlans:
test (4094)
=============================================================================
NOTE
The output differs if the port is connected to a port running ExtremeWare software; the output shown above is
displayed when both connected ports are running ExtremeWare XOS software.
History
This command was first available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms.
372
vlan-pdu-tx=1465
vlan-pdu-rx=2511
None
Oban
00:00:00:30:48:41:ed:97
11.1.0.19
1:1
Ethernet
OFF
SYMMETRIC/ASYMMETRIC
Configured = HALF
Configured = ERROR
Age = 41
pdu-tx-err=0
pdu-rx-err=0
Age = 41
Actual = HALF
Actual = 100 Mbps
ExtremeWare XOS 11.5 Command Reference Guide