Configure Tacacs Server - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

configure tacacs server

configure tacacs [primary | secondary] server [<ipaddress> | <hostname>]
{<tcp_port>} client-ip <ipaddress> {vr <vr_name>}
Description
Configures the server information for a TACACS+ authentication server.
Syntax Description
primary
secondary
ipaddress
hostname
tcp_port
ipaddress
vr_name
Default
TACACS+ uses TCP port 49. The default virtual router is VR-Mgmt, the management virtual router
Usage Guidelines
NOTE
The BlackDiamond 8800 series switch and the Summit X450 family of switches do not support user-created VRs.
Use this command to configure the server information for a TACACS+ server.
To remove a server, use the following command:
unconfigure tacacs server [primary | secondary]
Use of the parameter requires that DNS be enabled.
<hostname>
Example
The following command configures server tacacs1 as the primary TACACS+ server for client switch
10.10.20.35 using a virtual router interface of VR-Default:
configure tacacs primary server tacacs1 client-ip 10.10.20.35 vr vr-Default
ExtremeWare XOS 11.5 Command Reference Guide
Configures the primary TACACS+ server.
Configures the secondary TACACS+ server.
The IP address of the TACACS+ server being configured.
The host name of the TACACS+ server being configured.
The TCP port to use to contact the TACACS+ server.
The IP address used by the switch to identify itself when communicating with
the TACACS+ server.
Specifies the virtual router on which the client IP is located.
NOTE: The BlackDiamond 8800 series switch and the Summit X450 family of
switches do not support user-created VRs.
configure tacacs server
977