Create Traffic Queue Ingress-Only - Extreme Networks ExtremeWare XOS Command Reference Manual

Software version 11.5

Hide thumbs Also See for ExtremeWare XOS:

Table of Contents

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

create traffic queue ingress-only

create traffic queue <queue_name> ingress-only [strict-priority]

Creates an ingress-only traffic queue for use in ingress-only and ingress and egress HQoS rate limiting.

You cannot associate any egress shaping with this traffic queue; you can perform HQoS on ingressing

traffic only. Rate limiting allows you to control bandwidth throughout the network.

Syntax Description

Usage Guidelines

This command allows you to rate limit the HQoS ingress traffic stream as defined in this queue. You

cannot perform any egress HQoS on these ingress-only queues.

Strict priority provides a traffic queue with the following three levels of priority: high, medium, and

low. Strict priority HQoS supports one rate as an aggregate rate for the queue and can be associated

with an aggregate peak limit.

Look at the counters (using the

command) to see how the traffic is flowing.

The following command creates the HQoS ingress-only strict priority traffic queue test:

create traffic queue test ingress-only strict-priority

This command was first available in ExtremeWare XOS 11.4.

Platform Availability

This command is available only on the BlackDiamond 12804 R-Series switch.

ExtremeWare XOS 11.5 Command Reference Guide

Enter the name of the ingress-only traffic queue you are configuring. This

traffic queue rate limits only ingressing traffic.

show traffic queue [port <port_list> | <queue_name>]

create traffic queue ingress-only

Extremeware xos 11.5