Show Svlan - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

show svlan

show svlan {<svlan_name> {ipv4 | ipv6}} {detail}
Description
Displays SVLAN configuration. SVLANs are used in MAC-in-MAC tunneling (IEEE 802.1ah)
configurations.
Syntax Description
svlan_name
ipv4
ipv6
detail
Default
Summary information for all SVLANs on the device.
Usage Guidelines
None.
NOTE
To display the EtherType for IEEE 802.1ah MAC-in-MAC tunneling, use the command show vman ethertype.
Example
The following is an example of the display from the
* BD-10808.8 # show svlan
--------------------------------------------------------------------------------------
Name VID
--------------------------------------------------------------------------------------
servtest 4090 -------------------- ----------------S
--------------------------------------------------------------------------------------
Flags : (C) EAPS Control vlan, (E) ESRP Enabled, (f) IP Forwarding Enabled,
(i) ISIS Enabled, (I) IP Forwarding lpm-routing Enabled, (L) Loopback
Enabled, (m) IPmc Forwarding Enabled,
(n) IP Multinetting Enabled, (N) Network LogIn vlan,
(o) OSPF Enabled, (p) PIM Enabled,
ExtremeWare XOS 11.5 Command Reference Guide
Specifies information is displayed for particular SVLAN.
Not supported in ExtremeWare XOS version 11.4.
Not supported in ExtremeWare XOS version 11.4.
Specifies all information is displayed for each SVLAN.
Protocol Addr
command:
show svlan
Flags
show svlan
Proto Ports Virtual
Active router
/Total
ANY 0 /0 VR-Default
779