Configure Vlan Add Ports - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

configure vlan add ports

configure vlan <vlan_name> add [ports <port_list> | all] {tagged |
untagged} {stpd <stpd_name> {dot1d | emistp | pvst-plus}}
Description
Adds one or more ports in a VLAN.
Syntax Description
vlan_name
port_list
all
tagged
untagged
stpd_name
dot1d | emistp | pvst-plus
Default
Untagged.
Usage Guidelines
The VLAN must already exist before you can add (or delete) ports: use the
create the VLAN.
If the VLAN uses 802.1Q tagging, you can specify tagged or untagged port(s). If the VLAN is untagged,
the ports cannot be tagged.
Untagged ports can only be a member of a single VLAN. By default, they are members of the default
VLAN (named Default). In order to add untagged ports to a different VLAN, you must first remove
them from the default VLAN. You do not need to do this to add them to another VLAN as tagged
ports. if you attempt to add an untagged port to a VLAN prior to removing it from the default VLAN,
you see the following error message:
Error: Protocol conflict when adding untagged port 1:2. Either add this port as
tagged or assign another protocol to this VLAN.
As each port can belong to only one virtual router, ports within one VLAN must all be in the same
virtual router.
NOTE
All ports and VLANs are in VR-Default in the BlackDiamond 8800 series switch and Summit X450 family of
switches and cannot be moved.
ExtremeWare XOS 11.5 Command Reference Guide
Specifies a VLAN name.
Specifies a list of ports or slots and ports.
Specifies all ports.
Specifies the ports should be configured as tagged.
Specifies the ports should be configured as untagged.
Specifies an STP domain name.
Specifies the BPDU encapsulation mode for these STP ports.
configure vlan add ports
command to
create vlan
737