Modular Switch Numerical Ranges - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Command Reference Overview
NOTE
The keyword all acts on all possible ports; it continues on all ports even if one port in the sequence fails.
Stand-alone Switch Numerical Ranges
Commands that require you to enter one or more port numbers on a stand-alone switch, such as the
Summit X450 switch, use the parameter
A
<port_list>
5
A
<port_list>
contiguous numbers, and separate the numbers by a comma to enter a range of noncontiguous
numbers:
—Specifies a contiguous series of ports on a stand-alone switch.
●
x-y
—Specifies a noncontiguous series of ports on a stand-alone switch.
●
x,y
—Specifies a contiguous series of ports and a noncontiguous series of ports on a stand-alone
●
x-y,a,d
switch.

Modular Switch Numerical Ranges

Commands that require you to enter one or more port numbers on a modular switch, such as the
BlackDiamond 10K switch, use the parameter
slot is:
port <slot_number>:<port_number>
A
<port_list>
port 3:1
A <
port_list>
port 3:1-3:3
You can add additional slot and port numbers to the list, separated by a comma:
port 3:1,4:8,6:10
You can specify all ports on a particular slot, using the asterisk (*) wildcard. For example,
port 3:*
indicates all ports on slot 3.
You can specify a range of slots and ports. For example,
port 2:3-4:5
indicates slot 2, port 3 through slot 4, port 5.
42
<port_list>
can be a single port. For example, port 5 would be:
can also be a range of numbers. Separate the port numbers by a dash to enter a range of
can be one port on a particular slot. For example, port 1 on slot 3 would be:
can be a range of numbers. For example, ports 1 through 3 on slot 3 would be:
in the syntax.
in the syntax. The syntax for the port and
<port_list>
ExtremeWare XOS 11.5 Command Reference Guide