Ping - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Commands for Accessing the Switch

ping

ping {count <count> {start-size <start-size>} | continuous {start-size
<start-size>} | {start-size <start-size> {end-size <end-size>}}} {udp}
{dont-fragment} {ttl <ttl>} {tos <tos>} {interval <interval>} {vr <vrid>}
{ipv4 <host> | ipv6 <host>} {from} {with record-route}
Description
Enables you to send User Datagram Protocol (UDP) or Internet Control Message Protocol (ICMP) echo
messages or to a remote IP device.
Syntax Description
count
start-size
continuous
end-size
udp
dont-fragment
ttl
tos
interval
vr
ipv4
ipv6
host
from
with record-route
Default
N/A.
94
Specifies the number of ping requests to send.
Specifies the size, in bytes, of the packet to be sent, or the starting size if
incremental packets are to be sent.
Specifies that UDP or ICMP echo messages to be sent continuously. This
option can be interrupted by pressing [Ctrl} + C.
Specifies an end size for packets to be sent.
Specifies that the ping request should use UDP instead of ICMP.
Sets the IP to not fragment the bit.
Sets the TTL value.
Sets the TOS value.
Sets the time interval between sending out ping requests.
Specifies the virtual route to use for sending out the echo message. If not
specified, VR-Default is used.
NOTE: User-created VRs are not available on the BlackDiamond 8800 series
switch or the Summit X450 family of switches.
Specifies IPv4 transport.
Specifies IPv6 transport.
NOTE: If you are contacting an IPv6 link local address, you must specify the
VLAN you are sending the message from: ping <ipv6> <link-local
address> %<vlan_name> <host>.
Specifies a host name or IP address (either v4 or v6).
Uses the specified source address. If not specified, the address of the
transmitting interface is used.
Sets the traceroute information.
ExtremeWare XOS 11.5 Command Reference Guide