Configure Node Priority - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Commands for Managing the Switch

configure node priority

configure node slot <slot_id> priority <node_pri>
Description
Configures the priority of the node.
Syntax Description
slot_id
node_pri
Default
Default node priority is 0.
Usage Guidelines
Use this command to configure the priority of the node. The lower the number, the higher the priority.
The node priority is part of the selection criteria for the master node. The following list describes the
parameters used to determine the master node:
Node state—The node state must be STANDBY to participate in leader election and to be selected
●
master. If the node is in the INIT, DOWN, or FAIL states, the node will not participate in leader
election.
Configuration priority—This is a user assigned priority. The configured priority is compared only
●
after the node meets the minimum thresholds in each category for it to be healthy. Required
processes and devices must not fail.
Software health—This represents the percent of processes available.
●
Health of secondary hardware components—This represents the health of switch components, such
●
as the power supplies, fans, and so forth.
Slot ID—The MSM slot where the node is installed (MSM-A or MSM-B).
●
If you do not configure any priorities, MSM-A has a higher priority than MSM-B.
Example
The following command configures a priority of 2 for MSM-B:
configure node slot B priority 2
114
Specifies the slot of the node. A is for the MSM installed in slot A. B is for the
MSM installed in slot B.
Specifies the priority of the node. The default 0 gives MSM-A a higher priority
over MSM-B. The range is 1 to 100; 0 means you have not configured a node
priority.
ExtremeWare XOS 11.5 Command Reference Guide