Show Edp - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

show edp

show edp {ports [all | <ports>] {detail}}
Description
Displays connectivity and configuration information for neighboring Extreme Networks switches.
Syntax Description
ports
all
detail
Default
N/A.
Usage Guidelines
On a modular switch,
<ports>
be one or more port numbers. For a detailed explanation of port specification, see
Chapter 1, "Command Reference Overview."
command.
The neighbor-ID value is eight bytes. The first two bytes are always set to 00:00; the last six bytes are set
to the neighbor's system MAC address.
Use the command to display neighboring switches and configurations. This is most effective
show edp
with Extreme Networks switches.
Example
The following command displays the configuration of the switch:
show edp
Following is sample output from this command:
EDP advert-interval
EDP holddown-interval
EDP enabled on ports
Following is sample output from the
Port Neighbor
=============================================================================
1:1 Oban
=============================================================================
ExtremeWare XOS 11.5 Command Reference Guide
Specifies one or more ports or slots and ports.
Specifies all ports.
Show detailed information.
can be a list of slots and ports. On a stand-alone switch,
To clear the counters, use the
:60 seconds
:180 seconds
:1:1 1:2 1:3 1:4
show edp ports 1:1
Neighbor-ID
00:00:00:30:48:41:ed:97
"Port Numbering"
clear lacp counters
1:5 1:6 3:1 3:2 3:3
command:
Remote Age
Port
1:1 54
show edp
can
<portlist>
in
3:4
Num
Vlans
1
371