Extreme Networks ExtremeWare XOS Command Reference Manual page 584

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Commands for Status Monitoring and Statistics
Default
The following defaults apply to console display, memory buffer, NVRAM, and session targets:
timestamp—hundredths
●
date—mm-dd-yyyy
●
severity—on
●
event-name—condition
●
host-name—off
●
priority—off
●
process-name—off
●
process-slot—off (modular switches only)
●
source-line—off
●
The following defaults apply to syslog targets (per RFC 3164):
timestamp—seconds
●
date—mmm-dd
●
severity—on
●
event-name—none
●
host-name—off
●
priority—on
●
process-name—off
●
process-slot—off (modular switches only)
●
source-line—off
●
If a virtual router is not specified, VR-Mgmt is used.
Usage Guidelines
NOTE
The BlackDiamond 8800 series switch and the Summit X450 family of switches do not support user-created VRs.
This command configures the format of the items that make up log messages. You can choose to include
or exclude items and set the format for those items, but you cannot vary the order in which the items
are assembled.
When applied to the targets
the console display or telnet session. Configuration changes to the
console display target session, are in effect only for the duration of the session, and are not saved in
FLASH.
When this command is applied to the target
and
show log
overridden by specifying a format on the
When this command is applied to the target
to the specified syslog host.
584
or
console
commands. The format configured for the internal memory buffer can be
upload log
, the format specified is used for the messages sent to
session
, the format specified is used in subsequent
memory-buffer
and
show log upload log
, the format specified is used for the messages sent
syslog
ExtremeWare XOS 11.5 Command Reference Guide
target, be it either a telnet or
session
commands.