Extreme Networks ExtremeWare XOS Command Reference Manual page 194

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Commands for Managing the Switch
Example
The following command displays configured SNMP settings on the switch:
show management
The following is sample output from this command:
CLI idle timeout
CLI max number of login attempts : 3
CLI max number of sessions
CLI paging
CLI space-completion
CLI configuration logging
Telnet access
SSH access
SNMP access
Total Read Only Communities
Total Read Write Communities
RMON
SNMP Traps
SNMP v1/v2c TrapReceivers
SNMP stats:
SNMP traps:
History
This command was first available in ExtremeWare XOS 10.1.
The trap receiver source IP address, SNMP counter statistics, SSH access, CLI logging, and SNMP access
states was added to the
The enabled/disabled state for RMON was added to the
11.1.
Additional Telnet and SSH2 information about ACL usage was added to the
in ExtremeWare XOS 11.2.
Platform Availability
This command is available on all platforms.
194
: Disabled
: 8
: Enabled (this session only)
: Disabled (this session only)
: Disabled
: Enabled (tcp port 23 vr all)
: Access Profile : not set
: Enabled (Key valid, tcp port 22 vr all)
: Access Profile : not set
: Enabled
: 1
: 1
: Disabled
: Enabled
: None
InPkts 8619 OutPkts
Gets 8619 GetNexts
Sent 0 AuthTraps Enabled
output in ExtremeWare XOS 11.0.
show management
8619 Errors 0
0 Sets 0
show management
ExtremeWare XOS 11.5 Command Reference Guide
AuthErrors 0
output in ExtremeWare XOS
output
show management