Extreme Networks ExtremeWare XOS Command Reference Manual page 581

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
This command associates the specified filter and severity with the specified target. A filter limits
messages sent to a target.
Although each target can be configured with its own filter, by default, all targets are associated with the
built-in filter, DefaultFilter. Each target can also be configured with its own severity level. This provides
the ability to associate multiple targets with the same filter, while having a configurable severity level
for each target.
A message is sent to a target if the target has been enabled, the message passes the associated filter, the
message is at least as severe as the configured severity level, and the message output matches the
regular expression specified. By default, the memory buffer, NVRAM, primary MSM, and backup MSM
targets are enabled. For other targets, use the command
Table 13describes the default characteristics of each type of target.
Table 13: Default target log characteristics
Target Enabled
console no
display
memory yes
buffer
NVRAM yes
primary MSM yes
backup MSM yes
session no
syslog no
The built-in filter, DefaultFilter, and a severity level of
values may be overridden on a per-session basis using the
and specify the target as
changes:
configure log target session filter <filter name> {severity <severity> {only}}
Configuration changes to the current session target are in effect only for the duration of the session, and
are not saved in FLASH memory. The
changes are desired to be temporary. If changes to the console-display are to be permanent (saved to
FLASH memory), use the following form of the command:
configure log target console filter <filter name> {severity <severity> {only}}
Modular Switches Only. If the condition for the
primary, the event is sent to the backup MSM. When the backup MSM receives the event, it will see if
any of the local targets (nvram, memory, or console) are matched. If so it gets processed. The
and targets are disabled on the backup MSM, as they are handled on the primary. If the
syslog
condition for the
primary-msm
the primary MSM.
Note that the
backup-msm
only active on the backup MSM.
ExtremeWare XOS 11.5 Command Reference Guide
Severity Level
info
debug-data
warning
error
error
info
debug-data
. Use the following form of the command for per-session configuration
session
option can also be used on the console display, if the
session
backup-msm
target is met by a message generated on the backup, the event is sent to
target is only active on the primary MSM, and the
on page
enable log target
are used for each new telnet session. These
info
configure log target filter
target is met by a message generated on the
primary-msm
configure log target filter
647.
command
session
target is
581