Configure Sys-Recovery-Level - Extreme Networks ExtremeWare XOS Command Reference Manual

Software version 11.5

Hide thumbs Also See for ExtremeWare XOS:

Table of Contents

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

Commands for Status Monitoring and Statistics

configure sys-recovery-level

configure sys-recovery-level [all | none]

Configures a recovery option for instances where a software exception occurs in ExtremeWare XOS.

Syntax Description

The default setting is

Usage Guidelines

If the software fails, the switch automatically reboots or leaves the system in its current state. You must

specify one of the following parameters for the system to respond to software failures:

—The system will send error messages to the syslog and reboot if any software task exception

—No action is taken when a software task exception occurs. The system does not reboot, which

can cause unexpected switch behavior.

Use the none parameter only under the guidance of Extreme Networks Technical Support personnel.

If the system recovery level is

default setting and behavior, and Extreme Networks strongly recommends using the default setting.

Displaying the System Recovery Setting. To display the software recovery setting on the switch, use the

following command:

This command displays general switch information, including the software recovery level. The

following truncated output from a Summit X450 series switch displays the software recovery setting

(displayed as

SysLocation:

Configures ExtremeWare XOS to log an error into the syslog and reboot the

system after any software task exception occurs.

Configures the recovery level to none. No action is taken when a software task

exception occurs; there is no system reboot, which can cause unexpected

switch behavior.

NOTE: Use this parameter only under the guidance of Extreme Networks

Technical Support personnel.

, the system always reboots after a software task exception. This is the

Recovery Mode

TechPubs Lab

support@extremenetworks.com, +1 888 257 3000

ExtremeWare XOS 11.5 Command Reference Guide

Extremeware xos 11.5