Configure Vman Ratelimit Flood-Traffic Designated-Port - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
QoS Commands

configure vman ratelimit flood-traffic designated-port

configure vman <vman_name> ratelimit flood-traffic designated-port <port>
Description
Sets the vMAN port of which the system uses the rate-limit profile to control the flooding, multicast,
and broadcast traffic in a vMAN with egress rate-limiting applied.
Syntax Description
vman_name
port
Default
N/A.
Usage Guidelines
You enable egress rate limiting for a vMAN by using vMAN ACLs. (See
for information on vMAN ACLs.)
Once you apply egress rate limiting to a vMAN, you can configure how to control flooding, multicast,
and broadcast traffic on the specified vMAN. You specify one port in the vMAN as the designated port,
and the system applies the egress rate limiting profile of the designated port to send flood, multicast,
and broadcast traffic on all ports on that vMAN.
To display the port you designated to use the rate-limit profile that controls the flooding traffic for the
vMAN with egress rate limiting enabled, issue the
The following is sample output from this command (information is displayed on the ERL Designated
Port line):
VMAN Interface with name vman110 created by user
Admin State:
Priority:
Virtual router: VR-Default
IPv6:
STPD:
Protocol:
Loopback:
NetLogin:
ERL Designated Port:
QosProfile:
Ports:
Untag:
Tag:
898
Specifies the egress rate-limited enabled vMAN for which you are controlling
the flooding, multicast, and broadcast traffic.
Specifies the vMAN port of which you are using the rate-limit profile.
Enabled
802.1P Priority 0
None
None
Match all unfiltered protocols
Disabled
Disabled
6:2
QP1
4. (Number of active ports=4)
*2:1, *2:4
*6:1, *6:2
Chapter 14, "ACL Commands,"
command.
show vman detail
Tagging: 802.1Q Tag 110
ExtremeWare XOS 11.5 Command Reference Guide