Extreme Networks ExtremeWare XOS Command Reference Manual page 238

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Commands for Managing the Switch
When specifying a host name or remote IP address, the switch permits only the following characters:
Alphabetical letters, upper case and lower case (A-Z, a-z)
●
Numerals (0-9)
●
Period ( . )
●
Dash ( - ) Permitted only for host names
●
Underscore ( _ ) Permitted only for host names
●
Colon ( : )
●
When naming or configuring an IP address for your network server, remember the requirements listed
above.
Virtual Router Requirements. The
virtual router names at system boot-up are VR-Mgmt, VR-Control, and VR-Default; however, you can
only Telnet on VR-Mgmt and VR-Default. On the BlackDiamond 10808 switch, you can also create and
configure your own virtual routers. In ExtremeWare XOS 10.1, the valid virtual routers are VR-0, VR-1,
and VR-2 respectively, and Telnet used VR-0 by default. For more information about virtual routers, see
"Virtual Routers" in the ExtremeWare XOS Concepts Guide.
Example
The following command starts a Telnet client communication to the host at IP address 123.45.67.8:
telnet 123.45.67.8
The following command starts a Telnet client communication with a host named sales:
telnet sales
History
This command was first available in ExtremeWare XOS 10.1.
Support for the following virtual routers was added in ExtremeWare XOS 11.0: VR-Mgmt and
VR-Default.
Platform Availability
This command is available on all platforms.
238
option specifies the name of the virtual router. The valid
vr_name
ExtremeWare XOS 11.5 Command Reference Guide