Disable Diffserv Replacement Port - Extreme Networks ExtremeWare XOS Command Reference Manual

Software version 11.5

Hide thumbs Also See for ExtremeWare XOS:

Table of Contents

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

QoS Commands

disable diffserv replacement port

disable diffserv replacement port [<port_list> | all]

Disables the replacement of DiffServ code points in packets transmitted by the switch.

Syntax Description

Usage Guidelines

The DiffServ replacement feature is disabled by default.

BlackDiamond 10808 and 12804 switch only. If a port is in more than one virtual router, you cannot use

the DiffServ feature. The default VLAN DiffServ examinational mappings apply on ports in more than

one VR. If you attempt to configure DiffServ information on a port that is in more than one virtual

router, the system returns the following message:

Warning: Port belongs to more than one VR. Port properties related to diff serv and

code replacement will not take effect.

The specified ports are the ingress ports.

The following command disables DiffServ replacement on selected ports:

disable diffserv replacement ports 1:2,5:5,6:6

This command was first available in ExtremeWare XOS 11.0.

Platform Availability

This command is available on all platforms.

Specifies a list of ports or slots and ports to which the parameters apply. \

Specifies that DiffServ replacement should be disabled for all ports.

ExtremeWare XOS 11.5 Command Reference Guide

Extremeware xos 11.5