Extreme Networks ExtremeWare XOS Command Reference Manual page 656

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
Commands for Status Monitoring and Statistics
configured on that slot. For example, if the frequency of sending backplane diagnostic packets is 7
seconds, the polling value is 7 seconds.
Displaying the System Health Check Setting. To display the system health check polling setting on the
switch, use the following command:
show switch
As previously described, polling is always enabled on the switch, which is why you see the system
health check setting as Enabled. The following truncated output from a BlackDiamond 8810 switch
displays the system health check setting (displayed as
SysName:
SysName:
SysLocation:
SysContact:
System MAC:
SysHealth check:
Recovery Mode:
System Watchdog:
Example
The following command enables backplane diagnostic packets on slot 6:
enable sys-health-check slot 6
History
This command was first available in ExtremeWare XOS 10.1.
Platform Availability
This command is available only on modular switches.
656
TechPubs Lab
BD-8810Rack3
support@extremenetworks.com, +1 888 257 3000
00:04:96:1F:A2:60
Enabled
None
Enabled
):
SysHealth check
ExtremeWare XOS 11.5 Command Reference Guide