Clear Access-List Counter - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.
ACL Commands

clear access-list counter

clear access-list {dynamic} counter {<countername>} {any | ports <portlist>
| vlan <vlanname>} {ingress | egress}
Description
Clears the specified access list counters.
Syntax Description
dynamic
countername
any
portlist
vlanname
ingress
egress
Default
The default direction is ingress; the default ACL type is non-dynamic.
Usage Guidelines
Use this command to clear the ACL counters. If you do not specify an interface, or the
will clear all the counters.
Example
The following example clears all the counters of the ACL on port 2:1:
clear access-list counter port 2:1
The following example clears the counter counter2 of the ACL on port 2:1
clear access-list counter counter2 port 2:1
History
This command was available in ExtremeWare XOS 10.1.
The VLAN option was first available in ExtremeWare XOS 11.0.
The egress and dynamic options were first available in ExtremeWare XOS 11.3.
828
Specifies that the counter is from a dynamic ACL.
Specifies the ACL counter to clear.
Specifies the wildcard ACL.
Specifies to clear the counters on these ports.
Specifies to clear the counters on the VLAN.
Clear the ACL counter for packets entering the switch on this interface.
Clear the ACL counter for packets leaving the switch from this interface
(BlackDiamond 10808 and BlackDiamond 12804 only).
any
ExtremeWare XOS 11.5 Command Reference Guide
option, you