Unconfigure Log Target Format - Extreme Networks ExtremeWare XOS Command Reference Manual

ExtremeWare XOS 11.5 supports only the Summit X450 family of switches and the BlackDiamond 8800 series switch.

unconfigure log target format

unconfigure log target [console | memory-buffer | nvram | session | syslog
[all | <ipaddress> | <ipPort> {vr <vr_name>} [local0 ... local7]]] format
Description
Resets the log target format to its default values.
Syntax Description
console
memory-buffer
nvram
session
syslog
all
ipaddress
ipPort
vr_name
local0 ... local7
format
Default
When a target format is unconfigured, it is reset to the default values.
The following defaults apply to console display, memory buffer, NVRAM, and session targets:
timestamp—hundredths
●
date—mm-dd-yyyy
●
severity—on
●
event-name—condition
●
host-name—off
●
sequence-number—off
●
process-name—off
●
process-slot—on (modular switches only)
●
process-id—off
●
source-line—off
●
The following defaults apply to syslog targets (per RFC 3164):
timestamp—seconds
●
date—mmm-dd
●
ExtremeWare XOS 11.5 Command Reference Guide
Specifies the console display format.
Specifies the switch memory buffer format.
Specifies the switch NVRAM format.
Specifies the current session (including console display) format.
Specifies a syslog target format.
Specifies all remote syslog servers.
Specifies the syslog IP address.
Specifies the UDP port number for the syslog target.
Specifies the virtual router that can reach the server IP address.
NOTE: The BlackDiamond 8800 series switch and the Summit X450 family of
switches do not support user-created VRs.
Specifies the local syslog facility.
Specifies that the format for the target will be reset to the default value.
unconfigure log target format
711