Show Bootvar - Dell Networking 7048 Reference Manual

exit

show bootvar

Use the show bootvar command in User EXEC mode to display the active
system image file that the device loads at startup.
Syntax
show bootvar [
unit —Unit number.
•
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays the active system image file that the device
loads at startup.
console>show bootvar
Image Descriptions
image1 : default image
image2 :
Images currently available on Flash
------------------------------------------------------------------
unit image1
------------------------------------------------------------------
1 0.31.0.0
1446
Configuration and Image File Commands
unit
]
image2
0.31.0.0
current-active
image2
next-active
image2