Show Sntp Configuration; Commands In This Chapter - Dell Networking 7048 Reference Manual

multicast address ff02::101 (reserved for SNTP) for server packets on port
number 123. The client logic to handle packet contents doesn't change with
support for IPv6 networks.

Commands in this Chapter

This chapter explains the following commands:

show sntp configuration

show sntp server
show sntp status
sntp authenticate
sntp authentication-key
sntp broadcast client enable
sntp client poll timer
sntp server
show sntp configuration
Use the show sntp configuration command in Privileged EXEC mode to
show the configuration of the Simple Network Time Protocol (SNTP).
Syntax
show sntp configuration
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
1408
Clock Commands
sntp trusted-key
sntp unicast client enable
clock timezone hours-offset
no clock timezone
clock summer-time recurring
clock summer-time date
no clock summer-time
show clock