Port
Result
----
--------
1/0/1
OK
1/0/2
Short
1/0/3
Test has not been performed
1/0/4
Open
1/0/5
Fiber
show fiber-ports optical-transceiver
Use the show fiber-ports optical-transceiver command in Privileged EXEC
mode to display the optical transceiver diagnostics.
Syntax
show fiber-ports optical-transceiver [
interface — A valid fiber port.
•
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
The show fiber ports command is applicable to all fiber ports, including SFP,
SFP+, and XFP ports. It will display an error if executed against a copper port
or passive or active direct attach cables.
Examples
The following examples display the optical transceiver diagnostics.
console#show fiber-ports optical-transceiver
Port
1502
PHY Diagnostics Commands
Length [meters]
---------------
50
128
-
Temp
Voltage
Date
---------------
13:32:00 23 July 2004
13:32:08 23 July 2004
-
interface
]
Current
Output
Power
Input
TX
LOS
Power
Fault