Dell PowerConnect M6348 Cli Reference Manual page 72

Command line interface guide
Hide thumbs Also See for PowerConnect M6348:
Table of Contents

Advertisement

Command
dot1x max-users
dot1x port-control
dot1x re-authenticate
dot1x re-authentication
dot1x system-auth-control
dot1x timeout quiet-period
dot1x timeout re-authperiod
dot1x timeout server-timeout
dot1x timeout supp-timeout
dot1x timeout tx-period
show dot1x
show dot1x clients
show dot1x ethernet
show dot1x statistics
show dot1x users
dot1x guest-vlan
dot1x unauth-vlan
dot1x guest-vlan
show dot1x advanced
radius-server attribute 4
72
Description
Sets the maximum number of clients supported on the port
when MAC-based 802.1X authentication is enabled on the
port.
Enables manual control of the authorization state of the
port.
Manually initiates a re-authentication of all 802.1X-enabled
ports or a specified 802.1X enabled port.
Enables periodic re-authentication of the client.
Enables 802.1X globally.
Sets the number of seconds the switch remains in the quiet
state following a failed authentication attempt
Sets the number of seconds between re-authentication
attempts.
Sets the number of seconds the switch waits for a response
from the authentication server before resending the request.
Sets the number of seconds the switch waits for a response
to an EAP-request frame from the client before
retransmitting the request.
Sets the number of seconds the switch waits for a response
to an EAP-request/identify frame from the client before
resending the request.
Displays 802.1X status for the switch or the specified
interface.
Displays detailed information about the users who have
successfully authenticated on the system or on a specified
port.
Shows the status of MAC Authentication Bypass.
Displays 802.1X statistics for the specified interface.
Displays active 802.1X authenticated users for the switch.
Sets the guest VLAN on a port.
Specifies the unauthenticated VLAN on a port.
Defines a guest VLAN.
Displays 802.1X advanced features for the switch or
specified interface.
Sets the network access server (NAS) IP address for the
RADIUS server.
Mode*
IC
IC
PE
IC
GC
IC
IC
IC
IC
IC
PE
PE
PE
PE
PE
IC
IC
IC
PE
GC

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents