Dell PowerConnect M6348 Cli Reference Manual page 55

Command
ip arp inspection trust
ip arp inspection validate
ip arp inspection vlan
permit ip host mac host
show arp access-list
show ip arp inspection ethernet
show ip arp inspection statistics
show ip arp inspection vlan
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 49.
Ethernet Configuration
Command
clear counters
description
duplex
flowcontrol
interface ethernet
interface range ethernet
mtu
negotiation
show interfaces advertise
Description
Configures an interface as trusted for Dynamic ARP
Inspection.
Enables additional validation checks like source MAC
address validation, destination MAC address validation or
IP address validation on the received ARP packets.
Enables Dynamic ARP Inspection on a single VLAN or a
range of VLANs.
Configures a rule for a valid IP address and MAC address
combination used in ARP packet validation.
Displays the configured ARP ACLs with the rules.
Displays the Dynamic ARP Inspection configuration on all
the DAI enabled interfaces.
Displays the statistics of the ARP packets processed by
Dynamic ARP Inspection.
Displays the Dynamic ARP Inspection configuration on all
the VLANs in the given VLAN range.
Description
Clears statistics on an interface.
Adds a description to an interface.
Configures the full/half duplex operation of a given
Ethernet interface when not using auto-negotiation.
Configures the flow control on a given interface.
Enters the interface configuration mode to configure an
Ethernet type interface.
Enters the interface configuration mode to configure
multiple Ethernet type interfaces.
Enables jumbo frames on an interface by adjusting the
maximum size of a packet or maximum transmission
unit (MTU).
Enables auto-negotiation operation for the speed and
duplex parameters of a given interface.
Displays information about auto negotiation advertisement. PE
Mode*
IC
GC
GC
ARPA
PE
PE
PE
PE
Mode*
PE
IC
IC
GC
GC
GC
IC
IC
55