Figure 93: Serial Port Connector; Installing A Tx Matrix Management Ethernet Cable; Replacing A Tx Matrix Console Or Auxiliary Cable - Juniper TX MATRIX Hardware Manual

Installing a TX Matrix Management Ethernet Cable

Related
Documentation

Replacing a TX Matrix Console or Auxiliary Cable

Copyright © 2010, Juniper Networks, Inc.
Disconnect the cable from the network device.
3.
To remove a TX Matrix Management Ethernet Cable:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Plug one end of the replacement Ethernet cable into the appropriate
2.
Figure 92 on page 232 shows the external device ports on the TX-CIP. The port labeled
on connects to the Routing Engine in the upper Routing Engine slot
HOST TX-CIP-0
( RE0 ), and the port labeled
lower Routing Engine slot (
Plug the other end of the cable into the network device.
3.
TX Matrix Cables Overview on page 49
TX Matrix Connector Interface Panel (TX-CIP) Overview on page 38
TX Matrix Preventing Electrostatic Discharge Damage on page 298
TX Matrix Management Port Cable Specifications on page 345
RJ-45 Connector Pinouts for the TX Matrix Management ETHERNET Port on page 346
The port and
CONSOLE AUXILIARY
cable with DB-9 connectors. For cable specifications, see "DB-9 Connector Pinouts for
the TX Matrix Management AUXILIARY and CONSOLE Ports" on page 346.

Figure 93: Serial Port Connector

Chapter 24: Replacing TX Matrix Hardware Components
HOST on TX-CIP-1 connects to the Routing Engine in the
).
RE1
on the TX-CIPaccept an RS-232 (EIA-232) serial
port.
ETHERNET
233