Tx Matrix Router - Juniper TX MATRIX Hardware Manual

TX Matrix Hardware Guide
Tools and Parts Required for Integrating an Operational T640 Router with the TX Matrix
Router
170
See "Connecting the Fiber-Optic Array Cables to the TX Matrix Router" on page 137
and "Testing the TX Matrix Fiber-Optic Array Cables" on page 138.
Before you connect a T640 router to the TX Matrix router, you must perform the
3.
conversion tasks.
See "Overview of Converting a T640 Router" on page 161.
If any problems occur during the conversion procedure, you can convert the T640
router back to its original state.
Gather the tools required for the integration.
4.
"Tools and Parts Required for Integrating an Operational T640 Router with the
TX Matrix Router" on page 170.
Convert and connect the control planes between an operational T640 router and TX
5.
Matrix router.
See "Converting and Connecting the Control Planes Between an Operational T640
Router and the TX Matrix Router" on page 171
Integrate the switching plane between an operational T640 router and TX Matrix
6.
router.
See "Connecting and Testing a Switching Plane Between a T640 Router and TX Matrix
Router" on page 175.
To connect the TX Matrix router to an operational T640 router, you need the following
tools and parts:
Phillips (+) screwdriver, number 2
Small slotted screwdriver, at least 4 in. long (for the fiber-optic array connectors)
One fiber-optic array loopback connector for testing T640-SIBs
2.5-mm ball hex driver for the fiber-optic array loopback connector
Dust-free resealable plastic bags for temporary storage of fiber-optic array adapter
dust covers
Dry cloth cleaning tool for cleaning optical components
Use a dry cloth cleaning tool, such as USConec's In-Bulkhead-Connector (I.B.C.)
Cleaning Tool (see Figure 80 on page 171).
Copyright © 2010, Juniper Networks, Inc.