Replacing The Tx Matrix Rear Air Filter; Removing The Tx Matrix Rear Air Filter; Figure 101: Installing The Front Air Filter - Juniper TX MATRIX Hardware Manual

TX Matrix Hardware Guide
Related
Documentation

Replacing the TX Matrix Rear Air Filter

Removing the TX Matrix Rear Air Filter

242

Figure 101: Installing the Front Air Filter

TX Matrix Cooling System Overview on page 47
TX Matrix Preventing Electrostatic Discharge Damage on page 298
The rear air filter is located at the left rear edge of the chassis. The rear air filter weighs
less than 1 lb (0.5 kg).
Removing the TX Matrix Rear Air Filter on page 242
1.
Installing the TX Matrix Rear Air Filter on page 244
2.
To remove the rear air filter:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Loosen the captive screws at the top, center, and bottom of the air filter, using a
2.
Phillips (+) screwdriver, number 2.
Grasp the air filter cover by the captive screws and pull firmly to remove the cover and
3.
honeycomb assembly from the chassis (see Figure 102 on page 243).
Press the filter element inward until it clears the hooks at the top and bottom of the
4.
air filter slot, then push it to the left to unseat it.
Move the tabs on the filter element to a horizontal position.
5.
Grasp the tabs on the filter element and carefully pull it straight out from the chassis
6.
(see Figure 103 on page 244).
Copyright © 2010, Juniper Networks, Inc.