Figure 92: Tx Matrix Ethernet Port On The Tx-Cip; Removing A Tx Matrix Management Ethernet Cable - Juniper TX MATRIX Hardware Manual

TX Matrix Hardware Guide

Removing a TX Matrix Management Ethernet Cable

232

Figure 92: TX Matrix Ethernet Port on the TX-CIP

Removing a TX Matrix Management Ethernet Cable on page 232
1.
2. Installing a TX Matrix Management Ethernet Cable on page 233
To remove a TX Matrix Management Ethernet Cable:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Press the tab on the connector and pull the connector straight out of the port. Figure
2.
91 on page 231 shows the connector.
Copyright © 2010, Juniper Networks, Inc.