Figure 115: Removing A Tx-Sib - Juniper TX MATRIX Hardware Manual

TX Matrix Hardware Guide
258
When the TX-SIB is out of the chassis, do not hold it by its ejector handles
or edge connectors. They cannot support its weight.
Place one hand underneath the TX-SIB to support it, and slide it completely out of
10.
the chassis. Place it on the antistatic mat.
CAUTION: Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.
If you are not reinstalling a TX-SIB into the emptied TX-SIB slot within a short time,
11.
install a blank TX-SIB panel over the slot to maintain proper airflow in the TX-SIB card
cage.

Figure 115: Removing a TX-SIB

Copyright © 2010, Juniper Networks, Inc.