Figure 125: Rear Of The Power Supply Showing Midplane Connectors - Juniper TX MATRIX Hardware Manual

Copyright © 2010, Juniper Networks, Inc.
Loosen the captive screws on the lower corners of the power supply faceplate
9.
completely.
Twist the ejector handles on the upper corners of the faceplate counterclockwise to
10.
unseat the power supply.
Grasp the handle on the power supply faceplate and pull firmly. Slide it halfway out
11.
of the chassis (see Figure 126 on page 278).
CAUTION: Each three-input 240-A DC power supply weighs approximately
25 lb (11.3 kg). Be prepared to support the full weight of the power supply
as you remove it from the router.
Place one hand underneath the power supply to support it, and slide it completely
12.
out of the chassis.
WARNING: Do not touch the power connectors on the rear of the power
supply (see Figure 125 on page 277). They can contain dangerous voltages.

Figure 125: Rear of the Power Supply Showing Midplane Connectors

Chapter 24: Replacing TX Matrix Hardware Components
277