Figure 130: Standard Cable Restraint On A Three-Input 240-A Power Supply; Figure 131: Optional Cable Restraint On A Three-Input 240-A Power Supply; Replacing A Tx Matrix Dc Power Supply Cable - Juniper TX MATRIX Hardware Manual

TX Matrix Hardware Guide
Installing the Optional Cable Restraint on a Three-Input 240-A Power Supply

Replacing a TX Matrix DC Power Supply Cable

284
Figure 130: Standard Cable Restraint on a Three-Input 240-A Power
Supply
To install the optional cable restraint:
Align the two captive screws on the optional cable restraint with the two threaded
1.
holes located at the right edge of the power supply faceplate.
Fasten the captive screws.
2.

Figure 131: Optional Cable Restraint on a Three-Input 240-A Power Supply

You can use this procedure to replace a DC power cable for a two-input 160-A DC power
supply or three-input 240-A DC power supply.
Removing a TX Matrix DC Power Supply Cable on page 285
1.
Installing a TX Matrix DC Power Supply Cable on page 287
2.
Copyright © 2010, Juniper Networks, Inc.