Table 24: Cable Connections Between Tx-Cips And T-Cbs - Juniper TX MATRIX Hardware Manual

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Chapter 20: Integrating an Operational T640 Router with the TX Matrix Router
Hardware inventory:
Item
Chassis
Midplane
...
CB 0
(CB-T)
CB 1
(CB-T)
...
Plug one end of a UTP Category 5 cable into the appropriate RJ-45 port on
9.
Plug the other end of the cable into the port labeled
10.
appropriately.
NOTE: The RJ-45 port labeled
Plug one end of a UTP Category 5 cable into the appropriate RJ-45 port on
11.
Plug the other end of the cable into the port labeled
12.
appropriately.
Verify that the Ethernet connection LED on the left side of each T-CB
13.
green, which indicates a 100-Mbps connection.
NOTE: The connections between the TX-CIPs and the T-CBs are proprietary
Ethernet connections. Do not attempt to connect these components through
a switch or hub.

Table 24: Cable Connections Between TX-CIPs and T-CBs

TX-CIP-0 Port and Destination
— in
LCC0 T-CB-0 LCC0
— in
LCC1 T-CB-0 LCC1
— in
LCC2 T-CB-0 LCC2
— in
LCC3 T-CB-0 LCC3
Control Plane Connections Between the TX Matrix Router and T640 Router on page 10
TX Matrix Control Plane Cable Considerations on page 65
Overview of Integrating an Operational T640 Router with the TX Matrix Router on
page 169
Version Part number Serial number
65409
REV 03 710-005608 RA1395
REV 02 710-007655 HS5909
REV 02 710-007655 HS5910
on a T-CB is reserved for future use.
AUX
TX-CIP-1 Port and Destination
—
LCC0 T-CB-1
—
LCC1 T-CB-1
—
LCC2 T-CB-1
—
LCC3 T-CB-1
Description
T640
T640 Backplane
Control Board
Control Board
TX-CIP-0
CIP on T-CB-0 . Dress the cable
TX-CIP-1
on . Dress the cable
CIP T-CB-1
port is lit
CIP
in
LCC0
in
LCC1
in
LCC2
in
LCC3
.
.
173