Removing A Tx Matrix Pc Card; Installing A Tx Matrix Pc Card; Figure 109: Removing A Pc Card - Juniper TX MATRIX Hardware Manual

TX Matrix Hardware Guide

Removing a TX Matrix PC Card

Installing a TX Matrix PC Card

252
The PC Card is inserted into the slot labeled
the PC Card (see Figure 109 on page 252):
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
If the Routing Engine cover is in place, remove the cover by loosening the captive
3.
screws on the corners of its faceplate.
On the Routing Engine faceplate, press the eject button on the right side of the PC
4.
Card slot once to release the button. Press again to release the PC Card.
The PC Card pops partially out of the slot. Grasp the card and pull it completely out
5.
of the slot.
Place the PC Card on the antistatic mat.
6.
If you are not replacing the PC Card now, reinstall the Routing Engine cover and tighten
7.
the screws on the corners of the cover to secure it to the chassis.

Figure 109: Removing a PC Card

To install a PC Card (see Figure 110 on page 253):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
If the Routing Engine cover is in place, remove the cover by loosening the captive
2.
screws on the corners of its faceplate.
Insert the PC Card into the PC Card slot on the Routing Engine, with the Juniper
3.
Networks logo facing downward.
CAUTION: Be sure to insert the PC Card with the label facing downward.
Inserting the PC Card incorrectly might damage the Routing Engine.
on the Routing Engine. To remove
PC CARD
Copyright © 2010, Juniper Networks, Inc.