Figure 117: Using Soft Band Straps To Secure Fiber-Optic Array Cables - Juniper TX MATRIX Hardware Manual

TX Matrix Hardware Guide
264

Figure 117: Using Soft Band Straps to Secure Fiber-Optic Array Cables

Grasp the metal cover on the comb within the comb panel assembly that extends
4.
over the TX-SIB you will be connecting. Firmly pull the cover away from the chassis
until it is removed from the comb (see Figure 63 on page 115).
While aligning the fiber-optic array cable connector with its corresponding TX-SIB
5.
adapter, route the cable upward along the comb tooth, and press it into the tooth.
Use the tooth closest to the chassis to support a cable destined to any TX-SIB adapter
labeled , use the next tooth away from the chassis to support a cable destined
LCC0
to any TX-SIB adapter labeled
Reinstall the metal cover on the comb by firmly pressing it toward the chassis until it
6.
stops.
Route the other end of the fiber-optic array cable to the T640-SIB adapter.
7.
Dress the fiber-optic array cable so it does not interfere with system airflow and
8.
maintenance access (see Figure 118 on page 265).
LCC1 , and so on (see Figure 64 on page 116).
Copyright © 2010, Juniper Networks, Inc.