Device; Figure 65: Console And Auxiliary Serial Port Connector - Juniper M40E Hardware Manual

Connecting the M40e Router to a Management Console or Auxiliary Device
Copyright © 2010, Juniper Networks, Inc.
All manuals and user guides at all-guides.com
To connect external devices to the Routing Engine management ports, perform the
following procedures:
Connecting the M40e Router to a Management Console or Auxiliary Device on page 113
Connecting the M40e Router to a Network for Out-of-Band Management on page 114
Connecting the M40e Router to an External Alarm-Reporting Device on page 115
To use a system console to configure and manage the Routing Engine, connect it to the
appropriate port on the CIP. To use a laptop, modem, or other auxiliary device,
CONSOLE
connect it to the appropriate
an RJ-45 connector. One RJ-45/DB-9 cable is provided with the router. To connect a
device to the other port, you must supply another cable. For cable specifications, see
"Routing Engine Interface Cable and Wire Specifications for the M40e Router" on page 288.
To connect a management console or auxiliary device:
Turn off the power to the console or auxiliary device.
1.
Plug the female end (shown in Figure 65 on page 113) of the provided serial cable into
2.
the appropriate CONSOLE
device ports on the CIP. The ports labeled
the upper Routing Engine slot (
Routing Engine in the lower Routing Engine slot (
Using a 2.5-mm flat-blade screwdriver, tighten the screws on the connector.
3.
Attach the other end of the cable to the console or auxiliary device.
4.

Figure 65: Console and Auxiliary Serial Port Connector

Chapter 11: Connecting the M40e Router to External Devices
port on the CIP. Both ports accept a cable with
AUXILIARY
or AUXILIARY port. Figure 66 on page 114 shows the external
HOST 0 connect to the Routing Engine in
RE 0 ), and the ports labeled
RE 1
HOST 1 connect to the
).
113