TX Matrix Hardware Guide
96
CAUTION: Be prepared to support the weight of the TX-SIB (approximately
35 lb [15.9 kg]) before you slide it completely out of the chassis.
When the TX-SIB is out of the chassis, do not hold it by its ejector handles
or edge connectors. They cannot support its weight.
Place one hand underneath the TX-SIB to support it, and slide it completely out of
5.
the chassis.
CAUTION: Do not stack hardware components on one another after you
remove them. Place each component on an antistatic mat resting on a
stable, flat surface.
Repeat the procedure for each of the remaining TX-SIBs.
6.
Figure 50: Removing a TX-SIB
Copyright © 2010, Juniper Networks, Inc.