Tx Matrix General Laser Safety Guidelines; Laser Safety Standards - Juniper TX MATRIX Hardware Manual

Related
Documentation
TX Matrix Laser and LED Guidelines and Warnings

TX Matrix General Laser Safety Guidelines

Copyright © 2010, Juniper Networks, Inc.
Appendix A: Safety and Regulatory Compliance Information for the TX Matrix Router
Attention Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10
degrés.
Warnung Keine Rampen mit einer Neigung von mehr als 10 Grad verwenden.
Avvertenza Non usare una rampa con pendenza superiore a 10 gradi.
Advarsel Bruk aldri en rampe som heller mer enn 10 grader.
Aviso Não utilize uma rampa com uma inclinação superior a 10 graus.
¡Atención! No usar una rampa inclinada más de 10 grados
Varning! Använd inte ramp med en lutning på mer än 10 grader.
General Safety Guidelines for M Series, MX Series, and T Series Routers on page 295
Maintenance and Operational Safety Warnings for M Series, MX Series, and T Series
Routers on page 314
TX Matrix General Laser Safety Guidelines on page 309
TX Matrix Laser and LED Safety Warnings on page 310
General Laser Safety Guidelines on page 309
Laser Safety Standards on page 309
General Laser Safety Guidelines
When working around lasers, observe the following safety guidelines to prevent eye injury:
Do not look into unterminated ports or at fibers that connect to unknown sources.
Do not examine unterminated optical ports with optical instruments.
Avoid direct exposure to the beam.
WARNING: Unterminated optical connectors can emit invisible laser
radiation. The lens in the human eye focuses all the laser power on the
retina, so focusing the eye directly on a laser source—even a low-power
laser—could permanently damage the eye.

Laser Safety Standards

TX-SIBs and T640-SIBs are equipped with laser transmitters, which are considered a
Class 1 Laser Product by the U.S. Food and Drug Administration, and are evaluated as a
Class 1M Laser Product per EN 60825–1 +A11 +A2 requirements.
309