TX Matrix Hardware Guide
Installing the Small Shelf
Related
Documentation
78
Insert a mounting screw into each of the nonthreaded holes in the recesses of the
3.
spacer bar to secure the spacer bar. Each hole should have a cage nut behind it.
Repeat Steps 2 and 3 for the other spacer bar.
4.
Tighten all the screws completely.
5.
Figure 40: Positioning the Spacer Bar on the Rack
On the back of each rear rack rail, partially insert a mounting screw into the hole
1.
containing the lowest cage nut.
Install the small mounting shelf on the back rack rails. Rest the bottom slot of each
2.
flange on a mounting screw. The small mounting shelf installs on the back of the rear
rails, extending toward the center of the rack. The bottom of the small mounting shelf
should align with the bottom of the large mounting shelf.
Partially insert screws into the open holes in the flanges of the small mounting shelf.
3.
Tighten all the screws completely.
4.
Rack Requirements for TX Matrix Routers on page 61
Removing the Center-Mounting Brackets on page 80
Copyright © 2010, Juniper Networks, Inc.