Table of Contents
Advertisement
Related
Documentation
Replacing a TX Matrix Routing Engine
Removing a TX Matrix Routing Engine
Copyright © 2010, Juniper Networks, Inc.
NOTE: For Routing Engines with two PC Card slots, use either slot. Do not
install more than one PC Card in the Routing Engine.
Press the card firmly all the way into the slot.
4.
Reinstall the Routing Engine cover and tighten the screws on the corners of the cover
5.
to secure it to the chassis.
Figure 110: Installing a PC Card
TX Matrix Routing Engine Description on page 26
TX Matrix Preventing Electrostatic Discharge Damage on page 298
The TX Matrix router can have one or two Routing Engines. They are located in the upper
rear of the chassis in the slots marked
to 2.4 lb (1.1 kg).
Removing a TX Matrix Routing Engine on page 253
1.
Installing a TX Matrix Routing Engine on page 255
2.
To remove a Routing Engine (see Figure 112 on page 255):
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Check whether the Routing Engine is functioning as the backup or as the master. Take
3.
the host subsystem offline as described in "Taking a TX Matrix Host Subsystem Offline"
on page 247.
Chapter 24: Replacing TX Matrix Hardware Components
and
. Each Routing Engine can weigh up
RE0
RE1
253
Advertisement
Table of Contents
Troubleshooting
