Cleaning The Tx Matrix And T640 Fiber-Optic Components Overview; Cleaning The Fiber-Optic Components - Juniper TX MATRIX Hardware Manual

TX Matrix Hardware Guide
Related
Documentation

Cleaning the TX Matrix and T640 Fiber-Optic Components Overview

Cleaning the Fiber-Optic Components

200
State
Temperature
Temperature (B)
Power:
GROUND
1.8 V
2.5 V
3.3 V
1.8 V bias
3.3 V bias
5.0 V bias
8.0 V bias
Power (B):
GROUND
1.8 V
2.5 V
3.3 V
1.8 V bias
3.3 V bias
5.0 V bias
8.0 V bias
For more information about using the CLI, see the Junos OS manuals.
TX Matrix Switch Interface Boards (TX-SIBs) Description on page 23
TX Matrix TX-SIB LEDs on page 24
TX Matrix TX-SIB LEDs on the Craft Interface on page 38
Troubleshooting the TX Matrix TX-SIBs and the Switching Planes on page 216
Cleaning the Fiber-Optic Components on page 200
Cleaning with a Dry Cloth Cleaning Tool on page 201
While you install the TX Matrix router or replace a fiber-optic array cable, small deposits
of oil, dust, and debris can enter the TX-SIB and T640-SIB fiber-optic array adapters,
the fiber-optic array cable connectors, and the loopback connectors and adapters used
to test the optical connections. These deposits can cause loss of light, reducing signal
power and causing intermittent problems with the optical connection.
We recommend that you use a dry cloth cleaning tool, such as USConec's
In-Bulkhead-Connector (I.B.C.) Cleaning Tool (see Figure 83 on page 201) to clean the
fiber-optic components. This tool removes dust and oil from the fiber optics.
NOTE: You can order the dry cloth cleaning tool (part number 8037) and
cleaning adapter (part number 8485) from REALM Communications Group.
Call 408-203-5956.
Online
44 degrees C / 111 degrees F
43 degrees C / 109 degrees F
0 mV
1787 mV
2488 mV
3306 mV
1792 mV
3286 mV
5020 mV
7230 mV
0 mV
1789 mV
2498 mV
3308 mV
1797 mV
3291 mV
4991 mV
7843 mV
Copyright © 2010, Juniper Networks, Inc.