Attaching The Tx Matrix Installation Handle; Lifting The Tx Matrix Chassis Manually; Figure 52: Attaching The Installation Handle - Juniper TX MATRIX Hardware Manual

TX Matrix Hardware Guide
Related
Documentation

Attaching the TX Matrix Installation Handle

Related
Documentation

Lifting the TX Matrix Chassis Manually

98
Overview of Installing the TX Matrix Chassis Without a Mechanical Lift on page 91
Lifting the TX Matrix Chassis Manually on page 98
Reinstalling the TX Matrix Components on page 100
The installation handles helps you install the TX Matrix chassis. You attach the installation
handle over the power supply slots of the chassis. To attach the handle:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Insert the captive screws of the handle into the holes previously occupied by the
2.
captive screws of the power supplies (see Figure 52 on page 98).
Tighten the screws, using a Phillips (+) screwdriver, number 2.
3.

Figure 52: Attaching the Installation Handle

Overview of Installing the TX Matrix Chassis Without a Mechanical Lift on page 91
Removing the TX Matrix Components on page 92
Lifting the TX Matrix Chassis Manually on page 98
CAUTION: Lifting the chassis and mounting it in a rack requires four people.
The empty chassis weighs approximately 240 lb (109 kg).
Copyright © 2010, Juniper Networks, Inc.