TX Matrix Hardware Guide
Reinstalling the Power Supplies
Related
Documentation
90
To reinstall the two power supplies in the chassis (see Figure 46 on page 90):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Switch both circuit breakers on the power supply faceplate to the off position (
2.
Using both hands, slide the power supply into the chassis until you feel resistance.
3.
Twist the ejector handles at the upper corners of the power supply faceplate clockwise
4.
until they stop.
Tighten the captive screws at the lower corners of the power supply faceplate to
5.
secure the power supply in the chassis.
Repeat the procedure for the other power supply.
6.
Figure 46: Reinstalling a Power Supply
Overview of Installing the TX Matrix Chassis Using a Mechanical Lift on page 85
Tools Required to Install the TX Matrix Chassis Using a Mechanical Lift on page 85
Copyright © 2010, Juniper Networks, Inc.
O
).