Replacing The Tx Matrix Craft Interface; Figure 104: Installing The Rear Air Filter - Juniper TX MATRIX Hardware Manual

Related
Documentation

Replacing the TX Matrix Craft Interface

Copyright © 2010, Juniper Networks, Inc.
Replace the air filter cover.
7.
Firmly tighten the captive screws at the top, center, and bottom of the filter cover to
8.
secure it to the chassis, using a Phillips (+) screwdriver, number 2.

Figure 104: Installing the Rear Air Filter

TX Matrix Cooling System Overview on page 47
TX Matrix Preventing Electrostatic Discharge Damage on page 298
The craft interface is located on the lower front of the TX Matrix router below the air filter.
The craft interface weighs approximately 2 lb (0.9 kg). The craft interface is hot-insertable
and hot-removable.
Removing the TX Matrix Craft Interface on page 246
1.
Installing the TX Matrix Craft Interface on page 246
2.
Chapter 24: Replacing TX Matrix Hardware Components
245