Reinstalling The Front Fan Trays; Figure 57: Reinstalling A Tx-Sib - Juniper TX MATRIX Hardware Manual

TX Matrix Hardware Guide

Reinstalling the Front Fan Trays

104

Figure 57: Reinstalling a TX-SIB

To reinstall the front fan trays (see Figure 58 on page 105):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Grasp one of the fan trays by its handles, and insert it straight into the chassis.
2.
Tighten the captive screw on each side of the fan tray faceplate to secure it in the
3.
chassis.
Repeat the procedure to reinstall the remaining fan tray.
4.
Copyright © 2010, Juniper Networks, Inc.